Call today for expert advice
Tel: 508-668-6044 Mon-Fri 9am - 5:00pm
-
Key Features
- The Fast Chip SMD Removal Kit is a quick and inexpensive way to remove SMD components from a PCB without a hot air station using only your soldering iron.
- Removes QFP's, PLCC's, SOIC's, and chip components under 300 degrees Fahrenheit
- Enough material to remove 8-10 SMD'S
- The Kit Contains: 2.7 ft. Fast Chip Removal Alloy - 1 2cc tube of SRA TF5000 No Clean Rework Paste Flux and complete Instructions for SMD Removal and Cleanup
The heart of the kit is a length of Fast Chip low temperature Removal alloy. This alloy is like a solder that melts at temperatures well below that of normal solder (79°C and 174°F) and stays liquid long enough to melt the existing solder, allowing you time to carefully remove the component.
Simply apply a liberal amount of the included flux to the pins of the chip that you want to remove, then use a soldering iron with a flat-edge tip to heat the pins while applying the low temperature alloy. The alloy will remain liquid for a few seconds while you coat all of the connections, once you've coated the pins you should be able to lift the chip free using tweezers or a hemostat. Clean the pads thoroughly and apply fresh solder and you're ready to solder a new part in place.
| SKU | SMDKIT |
| Weight (lbs) | 0.1000 |
| Free Shipping | Yes |
| Brand | Fast Chip |
| Manufacturer | SRA Soldering Products |
Upsell Products
